Ulrich
Well-known member
Did you print that with PLA or TPU?
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I was more thinking about the phone and vibration dampening ... rather than the heatThat one is just "PLA+" so it definitely won't handle any significant heat. It's probably only good to like 100 degrees or so at best (inside the cubby).
So after I play around with it a bit I am planning on getting one printed with heat resistant ABS or nylon.
... like I said, just a thoughtHmm, that is an interesting prospect. Although vibration should be much less of a concern if the phone is not "clamped" in to something as a portion of the shock is lost just in the ability of the phone to wiggle freely of what it is sitting on.
But I may noodle on that a little. Maybe a thin rubber sheet cut on a Cricut as an overlay.
But my phone case is soft TPU.
I am still working on finding specific connectors for the charger side of the wiring. The bike side uses a common BMW plug that is easy to find, but the connector for the charger side is harder to figure out. My first try was a BMW X1 fog light cable - grabbed a used one and it didn't work. Next attempt is on its way from eBay - I think I found that its an injector plug that is used on BMW, Audi & Volkswagen.
I designed a fancier plate and 3d printed it out. Don't judge me too much, it is my first 3D printer project ever. Also - I purposefully left it kind of with the rough sanded finish on top because I think it goes well with the bike - instead of shining it up...
View attachment 14207 View attachment 14208
View attachment 14209 View attachment 14210