Hi all
Following a trip to France on my R18 Classic for the D Day celebrations, whilst doing 75 MPH, I became aware of a change in the bikes behaviour I pulled over to check. Sure enough I had picked up a screw in the rear tyre. Fortunately, before leaving home I had added a product called 'Puncture Safe'. As a result, the tyre had deflated around 50 - 60 % before the Puncture Safe did its job and sealed the leak. I then limped 5 miles to a garage and topped up the pressure. I had to do this several times before the tyre would hold pressure fully. This allowed me to travel the 250 miles home without requiring recovery. On a Friday afternoon, none of the local tyre shops were interested in changing out the tube on the bike. It does look like a daunting job when looking at the bike however, a browse through YouTube showed this was not the case. I am now safely home and busy arranging a tube change.
During my troubles I contacted the manufacturer of Puncture Safe, who was extremely helpful and guided me through what I should do. This involved, due to my tyre having a tube, leave screw in place, top up tyre pressure to 50 psi plus if possible before riding slowly for a few miles. Ultimately I would like to use the tapes available and convert my tyres to tubeless. On tubeless tyres, Puncture Safe is even more successful and I might not have even noticed the screw outside of routine checks.
As a result of the success I had with this product I am ordering a large drum and adding to all my vehicles.
I have posted two pictures. One shows the screw still in place. The other shows the tyre as still well inflated following 250 mile journey home.
Following a trip to France on my R18 Classic for the D Day celebrations, whilst doing 75 MPH, I became aware of a change in the bikes behaviour I pulled over to check. Sure enough I had picked up a screw in the rear tyre. Fortunately, before leaving home I had added a product called 'Puncture Safe'. As a result, the tyre had deflated around 50 - 60 % before the Puncture Safe did its job and sealed the leak. I then limped 5 miles to a garage and topped up the pressure. I had to do this several times before the tyre would hold pressure fully. This allowed me to travel the 250 miles home without requiring recovery. On a Friday afternoon, none of the local tyre shops were interested in changing out the tube on the bike. It does look like a daunting job when looking at the bike however, a browse through YouTube showed this was not the case. I am now safely home and busy arranging a tube change.
During my troubles I contacted the manufacturer of Puncture Safe, who was extremely helpful and guided me through what I should do. This involved, due to my tyre having a tube, leave screw in place, top up tyre pressure to 50 psi plus if possible before riding slowly for a few miles. Ultimately I would like to use the tapes available and convert my tyres to tubeless. On tubeless tyres, Puncture Safe is even more successful and I might not have even noticed the screw outside of routine checks.
As a result of the success I had with this product I am ordering a large drum and adding to all my vehicles.
I have posted two pictures. One shows the screw still in place. The other shows the tyre as still well inflated following 250 mile journey home.