You will only need two wires (ground and light) for the lights unless you tie both leads together to power both bulbs at the same time. The US models send 5VDC for running, 12 VDC for brake and for turn just alternate voltage to blinks the lights. I don’t think you will need the resistor If...
I ran into the same problem With the PWM CANbus lights. The euro lights use more wires due to the amber lights. Similar to the US factory lights, I used only a ground and the red light wire. The US models send 5VDC for running, 12 VDC for brake and for turn just alternate voltage to blinks...
I have changed front and back on my bike. The front picture of my bike shows how hidden they are as they are only about 3/8” in diameter. The front I used Kellermann ATTO mini lights up front. Very bright and you don’t know they are there. Just buy the lights, no other hardware necessary...
I completed the rear light replacement and wire harness. My bike is the factory BMW Bobber kit so unfortunately I was stuck with the BMW light mounts. I did not care for the factory arrow lights so I decided to replace with round lights for a traditional look. I measured and made drawings and...
I got all the lighting working with the WUNDERLICH harness (similar to your harness) and the lights work great. My friend and I pulled all new wires from the lights back to the plug and soldered all connections.
If you have any questions, let me know.
Hello Everyone,
Im working on replacing my rear tail lights on the R18. Has anyone found a solution to replacing the OEM can-bus lights with LED lights? I see Wunderlich US has a harness and not sure if that is what I need.