Recent content by 4Zweistein

the magnetic Oil plug had absolutely nothing attached to it. when you rub the oil between your fingers it is incredibly slick compared to Amsoil that I had sitting around in the garage. The 300V exceeds all Api specs.

I finally got around to install the oil temperature gauge. The sensor is installed in the oil drain plug. I took the power from the left side accessory plug. I actually cut the plug and installed a fused accessory block with 4 outlets. I noticed that in stop and go driving here in Florida at...

In my owners manual is actually a picture and instructions on how to display the oiltemp in the the cluster. But I tried and the value cannot be displayed on mine.

I am planning on installing a oil temperature gauge on my R18 C. When I do my upcoming oil change I will install a M16x1.5 adapter plug with a 1/8 NPR sensor instead of the OEM drain plug. the wiring is pretty straight forward. I will tap into switched power at the plug under the left battery...

I converted my rims to tubeless and couldn't be happier with the result!

No issue whatsoever! The tires hold the pressure better than with the tubes. I had a very slight leak in the beginning on the front wheel but that was because the tire bead was leaking against the rim. I released the air and reinflated it hitting th tire with a rubber mallet and it sealed...

here is a screenshot

According to my owners manual a should have a setting in the instrument cluster that shows the oil temperature. I cant get to show. I have an appointment with the dealer next week. anyone else have a problem with this?

According to my owners manual I should have a setting that shows the Oil temperature in the instrument cluster. Mine does not show it. Have an appointement with the dealer next week. Anybody else had this problem?

I should have done the same. I think I switch them out the next time a new tire is due.

Almost no play whatsoever. After it's tightened it absolutely does not move.

I got mine from NAPA Part#NTH 90426 they are .337 in or 8.56 mm and fit perfect

8.3mm, but to be sure messure the size of the tube valve stem

I ordered a 3pin plug from Ali Express just to see whether it would work with the Pigtail under the left side cover above the battery. I will post updates when I get it.

The way I did mine I can also get to each individual spoke to reseal it if I had to and then reseal it. I didn't like the outex kit because I don't think it would have performed well on these rims. The heads of the spokes protrude quite a bit at an angle that I don't think these "stickers" would...